Linux version 2.6.0 (root@Maksik) (gcc version 3.2.3 (Debian)) #1 Sun Dec 28 18:37:45 EST 2003
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009ec00 (usable)
 BIOS-e820: 000000000009ec00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000cc000 - 00000000000d0000 (reserved)
 BIOS-e820: 00000000000e0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 000000000f6f0000 (usable)
 BIOS-e820: 000000000f6f0000 - 000000000f6ff000 (ACPI data)
 BIOS-e820: 000000000f6ff000 - 000000000f700000 (ACPI NVS)
 BIOS-e820: 000000000f700000 - 000000000f800000 (usable)
 BIOS-e820: 00000000fffe0000 - 0000000100000000 (reserved)
248MB LOWMEM available.
On node 0 totalpages: 63488
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 59392 pages, LIFO batch:14
  HighMem zone: 0 pages, LIFO batch:1
DMI 2.3 present.
ACPI: RSDP (v000 PTLTD                                     ) @ 0x000f6c90
ACPI: RSDT (v001 PTLTD    RSDT   0x06040000  LTP 0x00000000) @ 0x0f6fb061
ACPI: FADT (v001 CUSTOM ND000039 0x06040000 PTL_ 0x000f4240) @ 0x0f6fef64
ACPI: BOOT (v001 PTLTD  $SBFTBL$ 0x06040000  LTP 0x00000001) @ 0x0f6fefd8
ACPI: DSDT (v001 CUSTOM ND000039 0x06040000 MSFT 0x0100000d) @ 0x00000000
Building zonelist for node : 0
Kernel command line: root=/dev/hda5 vga=5
Initializing CPU#0
PID hash table entries: 1024 (order 10: 8192 bytes)
Detected 933.267 MHz processor.
Console: colour VGA+ 80x34
Memory: 247236k/253952k available (2057k kernel code, 5912k reserved, 838k data, 112k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay loop... 1830.91 BogoMIPS
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
CPU:     After generic identify, caps: 00803135 80803135 00000000 00000000
CPU: L1 I Cache: 64K (32 bytes/line), D cache 64K (32 bytes/line)
CPU: L2 Cache: 64K (32 bytes/line)
CPU:     After all inits, caps: 00803135 80803135 00000000 00000000
CPU: Centaur VIA C3 Ezra stepping 09
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfd79e, last bus=1
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20031002
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (00:00)
PCI: Probing PCI hardware (bus 00)
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs 9 12 13)
ACPI: PCI Interrupt Link [LNKB] (IRQs *10 12 13)
ACPI: PCI Interrupt Link [LNKC] (IRQs 5 12 13)
ACPI: PCI Interrupt Link [LNKD] (IRQs 10 12 13)
ACPI: Embedded Controller [EC] (gpe 6)
SCSI subsystem initialized
Linux Kernel Card Services
  options:  [pci] [pm]
drivers/usb/core/usb.c: registered new driver usbfs
drivers/usb/core/usb.c: registered new driver hub
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 11
ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 11
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 10
ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 9
PCI: Using ACPI for IRQ routing
PCI: if you experience problems, try using option 'pci=noacpi' or even 'acpi=off'
SBF: Simple Boot Flag extension found and enabled.
SBF: Setting boot flags 0x1
longhaul: VIA C3 'Ezra-T' [C5M] CPU detected. Longhaul v2 supported.
longhaul: Bogus values Min:0.000 Max:0.000. Voltage scaling disabled.
longhaul: MinMult=5.0x MaxMult=7.0x
longhaul: FSB: 133MHz Lowestspeed=665MHz Highestspeed=931MHz
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
NTFS driver 2.1.5 [Flags: R/W].
udf: registering filesystem
pty: 256 Unix98 ptys configured
Linux agpgart interface v0.100 (c) Dave Jones
agpgart: Detected VIA ProSavage PM133/PL133/PN133 chipset
agpgart: Maximum main memory to use for agp memory: 197M
agpgart: AGP aperture is 64M @ 0xec000000
loop: loaded (max 8 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: IDE controller at PCI slot 0000:00:07.1
VP_IDE: chipset revision 6
VP_IDE: not 100% native mode: will probe irqs later
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
VP_IDE: VIA vt82c686b (rev 42) IDE UDMA100 controller on pci0000:00:07.1
    ide0: BM-DMA at 0x1c20-0x1c27, BIOS settings: hda:DMA, hdb:pio
hda: FUJITSU MHS2020AT E, ATA DISK drive
Using anticipatory io scheduler
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
hda: max request size: 1024KiB
hda: 39070080 sectors (20003 MB) w/2048KiB Cache, CHS=16383/255/63, UDMA(100)
 hda: hda1 hda2 hda3 hda4 < hda5 >
ehci_hcd 0000:00:0d.2: EHCI Host Controller
ehci_hcd 0000:00:0d.2: irq 10, pci mem d001f000
ehci_hcd 0000:00:0d.2: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:0d.2: USB 2.0 enabled, EHCI 0.95, driver 2003-Jun-13
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 5 ports detected
ohci_hcd: 2003 Oct 13 USB 1.1 'Open' Host Controller (OHCI) Driver (PCI)
ohci_hcd: block sizes: ed 64 td 64
ohci_hcd 0000:00:0d.0: OHCI Host Controller
ohci_hcd 0000:00:0d.0: irq 9, pci mem d0021000
ohci_hcd 0000:00:0d.0: new USB bus registered, assigned bus number 2
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 3 ports detected
ohci_hcd 0000:00:0d.1: OHCI Host Controller
ohci_hcd 0000:00:0d.1: irq 11, pci mem d0023000
ohci_hcd 0000:00:0d.1: new USB bus registered, assigned bus number 3
hub 2-0:1.0: new USB device on port 2, assigned address 2
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 2 ports detected
Initializing USB Mass Storage driver...
drivers/usb/core/usb.c: registered new driver usb-storage
USB Mass Storage support registered.
drivers/usb/core/usb.c: registered new driver hid
drivers/usb/input/hid-core.c: v2.0:USB HID core driver
mice: PS/2 mouse device common for all mice
input: PS/2 Generic Mouse on isa0060/serio1
serio: i8042 AUX port at 0x60,0x64 irq 12
input: AT Translated Set 2 keyboard on isa0060/serio0
serio: i8042 KBD port at 0x60,0x64 irq 1
Advanced Linux Sound Architecture Driver Version 0.9.7 (Thu Sep 25 19:16:36 2003 UTC).
PCI: Setting latency timer of device 0000:00:07.5 to 64
input: USB HID v1.10 Mouse [Logitech USB Optical Mouse] on usb-0000:00:0d.0-2
ALSA device list:
  #0: VIA 82C686A/B rev50 at 0x1000, irq 11
NET: Registered protocol family 2
IP: routing cache hash table of 2048 buckets, 16Kbytes
TCP: Hash tables configured (established 16384 bind 32768)
NET: Registered protocol family 1
NET: Registered protocol family 17
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Freeing unused kernel memory: 112k freed
Unable to find swap-space signature
EXT3 FS on hda5, internal journal
8139too Fast Ethernet driver 0.9.26
eth0: RealTek RTL8139 at 0xd004d400, 00:03:25:05:43:33, IRQ 10
eth0:  Identified 8139 chip type 'RTL-8139C'
Unable to find swap-space signature
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1